1、成分内不含Ph、cr、Hg等重金属；

1. The ingredients do not contain heavy metals such as Ph, Cr, Hg, etc;

2、归属于厚膜型材料，触变性能好，经充分搅拌后，少加或不加稀释剂，即可涂装施工。由于镀锌固体分含量高达77％，固线器，一次无气喷涂可获得较高的膜厚，减少了有机溶剂的挥发量，降低干燥能耗，这些均有利于环境保护。

2. Belonging to thick film materials, it has good thixotropic performance. After sufficient stirring, with or without the addition of diluents, painting construction can be carried out. Due to the high solid content of 77% in zinc plating, a fixed wire machine and a single airless spraying can achieve higher film thickness, reduce the volatilization of organic solvents, and lower drying energy consumption, all of which are beneficial for environmental protection.

3、经过测试证明：绝大多数镀锌的溶剂和稀释剂内不含甲苯、酮类、卤代烃等毒性大的有机溶剂。

3. After testing, it has been proven that the vast majority of solvents and diluents for galvanizing do not contain toxic organic solvents such as toluene, ketones, halogenated hydrocarbons, etc.

4、镀锌电缆桥架是替代热浸镀锌、电弧(热)喷锌的好材料，对减少三废、降低能耗，提高环境保护的社会效益的作用就更加明显。

4. Galvanized cable tray is a good material to replace hot-dip galvanizing and arc (hot) spraying zinc, which plays a more significant role in reducing three wastes, reducing energy consumption, and improving the social benefits of environmental protection.

镀锌电缆桥架设备的三点自我检修事项

Three self inspection items for galvanized cable tray equipment

1 、电缆桥架设备平衡气缸动作状况及其机油润滑系统油路,接头等测试检查.

1. Test and inspect the operation status of the balance cylinder of cable tray equipment, as well as the oil circuit and joints of the oil lubrication system

2 、电缆桥架设备滑块与导轨之间的摩擦较为频繁，应做必要的调整较正，检查接头部位的润滑优质及管路等，保证良好的运转。

2. The friction between the sliding block and the guide rail of the cable tray equipment is relatively frequent, and necessary adjustments should be made to ensure proper alignment. The lubrication of the joint parts and pipelines should be checked to ensure good operation.

3 、定期为电缆桥架设备齿轮部位润滑：齿轮传动箱及内部机件因为经常运转损坏的可能性比较大，出现松动的可能性更大。当这些部位出现噪音后，可先对此进行润滑，然后根据振动情况，检查系统之间的的注油点的吐油量和压力测试，进行适当的调整。

3. Regularly lubricate the gear parts of cable tray equipment: The possibility of damage to the gear transmission box and internal components due to frequent operation is higher, and the possibility of looseness is greater. When there is noise in these areas, lubrication can be carried out first, and then according to the vibration situation, the oil dispensing amount and pressure test of the oil injection points between the systems can be checked, and appropriate adjustments can be made.

感谢您的阅读，此文的文章来源：山东电缆桥架更多的内容和问题请点击：//www.comprepyme.com我们会继续努力的为您提供服务，感谢您的支持！

Thank you for reading. The source of this article is Shandong Cable Tray. For more information and questions, please click: //www.comprepyme.com We will continue to work hard to provide you with services. Thank you for your support!